You requested a simple way to plasma cut bolt holes and we took it a
step further. Not only is this an effective tool that looks cool, but it
functions better with four sides and a center section for clamping.
Holey Cross will make plasma cutting bolt holes a breeze when you don't want to
use a drill.
-1/4", 5/16", 3/8", and 1/2" bolt holes offset for a loose fit with no clean up
-Laser cut and etched from 1/8" cold rolled steel
-Center line marks allow easy location for bolt hole
-Use the pictured chart to find your drag shield diameter - If you have a PT or IPT torch, then you will need the drag shield conversion kit we also sell. Plasma cutters not listed will need our plasma conversion/offset rings available separately. Not all plasma cutters will drag cut properly.
The Plasma Stencil will guide your hand held plasma cutter to quickly
and accurately cut a perfect bolt hole. The stencil has zero offset so
the bolt will have play without any cleanup. Available for most plasma
cutters that have a drag shield attachment. Laser cut and etched from
1/8" (11ga.) cold rolled steel. The end result is a quick, clean and
accurate cut that can be done anywhere. Made in the USA.
for use with a drag shield attachment use the chart in the pictures to
determine the proper size for your plasma cutter. If your plasma cutter
is not listed, then you will need to measure your drag shield to find
the proper size Plasma Stencil to use. Some models do not offer a drag
shield attachment and will not work properly with our Plasma Stencils.