The Plasma Stencils will guide your hand held plasma cutter to quickly and accurately cut a perfect square. The stencils are offset to precisely cut the indicated size from the center of the arc, this allows a little clearance for easy assembly. Each kit includes 5 stencils for 10 sizes: squares range from ¼"-2". Available for most plasma cutters that have a drag shield attachment. The outside edges act as bonus square cutting guides. Laser cut and etched from 1/8" cold rolled steel. The end result is a quick, clean and accurate cut that can be done anywhere. Made in the USA.
-Use the pictured chart to find your drag shield diameter - If you have a PT or IPT torch, then you will need the drag shield conversion kit we also sell. Plasma cutters not listed will need our plasma conversion/offset rings available separately. Not all plasma cutters will drag cut properly.
1/4", 3/8", 1/2" sizes are under sized by .060" to make a tight fitting hole for carriage bolts to be held in place.
Select a row below to filter reviews.
5.0
