This 6" oval Plasma Stencil has been specifically designed for flush mount or recessed trailer lights. It will work with any grommet style flush mount light. The Plasma Stencils will guide your hand held plasma cutter to quickly
and accurately cut a perfect oval. The stencils are offset so the light will fit, even if there's slag on the back side. Available for most plasma cutters that have a drag
shield attachment. The outside of the stencil can be used to make a simple light bracket. Laser cut and etched from 1/8" cold rolled steel. The end result is a
quick, clean and accurate cut that can be done anywhere. Made in the
Actual cut dimensions: 2 1/2" x 6 3/4"
Designed for use with a drag shield
attachment use the chart in the pictures to determine the proper size
for your plasma cutter. If your plasma cutter is not listed, then you
will need to measure your drag shield to find the proper size Plasma
Stencils to use. Some models do not offer a drag shield attachment and
will not work properly with our Plasma Stencils.
Excellent addition to my stock of stencils. Not only great for the trailer light cut outs but handy for inside and outside curves and short straights. Made with quality out of good steel. I really like that I can take the stencil to the steel instead of cutting the item on the plasma table and welding it on. A great time saver.
Reviewed by: John Kasper from Memphis TN.
Drag shield part numbers and specifications. Some models do not offer a
drag shield attachment and will not work properly with our stencils.
Eastwood - .420" drag shields (use Miller stencils)
Versacut 40 & 60 machines
Hobart - .380" drag shields (use Hypertherm stencils)
#770798 - 40i w/xt40 torch
#770799 - 27i w/xt30 torch
N/A - 12ci will not work
Hypertherm - .380" drag shields
N/A - pm30air will not work
#420116 - pm30xp
#220674 - pm45
#120828 - pm600
Hypertherm - .430" drag shields (use Miller Stencils)
#220818 - pm45xp
#220818 - pm65/85/105
#120929 - pmx 1000/1250/1650/rt60/rt80
Lincoln - .430" drag shields (use Miller stencils)
#KP2843-3 - lc40 torch/ Tomahawk 625
#KP2844-11 - lc65
Miller - .430" drag shields
375/625 with xt40 torch -
#251960 - 40 amp (use this one)
#249930 - 30 amp (has short shoulder, hard to use)
Miller - .580" drag shields (use Thermal D. stencils)
#225616 - 375 extreme w/ ice 25/27 torch
Thermal Dynamics / Victor - .580" drag shields
N/A - SL 40 torch will not work
SL 60/100 torch -
#9-8237 - threaded shield cup
#9-8244 - 40 amp
#9-8235 - 50-60 amp
#9-8236 - 70-100 amp
This video shows just how easy it is to use the Plasma Stencils and make a shock tab in a couple minutes.
This video shows more uses of the Plasma Stencils with the circle pro and slot stencils. It also shows how the Plasma Table makes the stencils even easier to use.