11/3/22 Discontinued - Check out our new plasma table roll-around's and CNC table toppers.
The Plasma Table will sit on top of a Behrens 17 gal. tub or standard 55 gal. drum, this creates a very economical and effective plasma cutting water table. All of the sparks/slag and most of the smoke is captured with a 5" air gap above the water. We include a quick release clamp with an
extended arm to firmly hold a straight edge, guide or our Plasma
Stencils. This allows you to use both hands for guiding your plasma
cutter to make precise cuts. Because the clamp can be positioned 360°
around the table, you can usually cut an entire small part out without
moving the material. The usable cutting area is 21".
The cutting slats just drop into place, which makes them easy to replace. They are 1/8" x 2" flat bar and 20 feet is required when purchased separately. The table requires welding to assemble, it will take about 30 minutes to layout, tack and weld. Bolts are included to attach the table to the tub, which makes it easy to move around. The Plasma Table just
rests on top of the tub, so it's easy to take apart and throw in the
corner when your not using it. The Behrens 17 gallon galvanized steel tub is a great choice for those that want a quick and easy set up. Most farm or hardware stores have them in stock and they are sold through many online stores, just make sure you get the Behrens brand. It takes about 10
gallons of water to get a 5" air gap. Or a standard 55 gallon drum can be cut down to 8" high and use 5 gallons