The 4-Point Jack Adapter offers the
versatility to hold just about anything that is large, heavy, and
awkward with your transmission or floor jack. Modular design allows easy assembly and
reconfiguration
for different objects. Easily converts most jacks to safely hold
front and rear solid axles, fuel tanks, transfer cases, manual
transmissions, bumpers, etc.
Click on the Videos tab to see all our YouTube videos of this in action!
We went all the way back to the drawing board for the new 4-point Jack Adapter. Our 1½" adapter pin allowed for the new design that's better suited for floor jacks, with threaded supports all around and includes a wrench to make adjustments with weight on it. For transmission jacks, the base adapter comes with two bolts to mount it (need to drill your jack plate) and it has two pins that locate the 4 Point Jack Adapter. Base plate is 3/8" thick and threaded for 1/2" bolts which hold the U-slot bars. This design makes it easy to center the jack under the load, then move the supports to find pick points. Included 8" Threaded Supports are 3/4" all-thread that can be replaced with custom lengths, 15" available.
- Top/main bars are 1/4"x 1¼", adjust from 7-28” wide and provide solid load points.
- Bottom/support bars are 3/16"x 1", adjust from 6-25” wide, they pivot around one bolt and stabilize the load.
- Minimum height is 6", Max height with 8" supports is 12" above jack base.
- 800 lbs. capacity at maximum extension, using just the top main bars.
- Comes with wrench for adjusting threaded supports and tightening bars.
- Made in Oregon, USA
4/29/23 - updated description, options, pictures & added thumbnails
