1:5 Scale - 4'x4' - RC Car Ramp Jump - DIY Frame ONLY - 35-60°

Write a Review

Your Price: $400.00

Part Number: RC-4x4-1.5

Availability: In Stock. FREE Shipping

- DIY Frame Only - Requires 4'x4' foot plywood or plastic for deck

- Includes frame, all hardware & start transition, pre drilled and countersunk 1/8" Lexan

- Adjustable legs from 35-60° in 5° increments. Set low for jumps over 100 feet long, or high for more than 30 feet of air!

- 1"x .125 wall aluminum frame is easy to assemble and takes the bashing abuse!

- Read description below for more infomation.

Quantity

Description

This 4'x4' ramp is the biggest and best ramp available for the largest RC cars/trucks out there. Launch over 100 foot gaps and 30 foot high jumps with this setup. Ramp is adjustable from 35° to 60° launch angles, with telescoping legs. Available in 1:8 & heavier duty 1:5 scale versions. The main design is similar to our other ramps with a separate start transition that allows the main ramp frame to stay planted on the ground. The start transition is 1/8" Lexan with a 3/4" HDPE cross bar that all comes pre-drilled and countersunk. This new design is flexible, but also uses the cross bar to stay in contact with the ground, this combo allows for a perfect solution for a long lasting ramp.

Assembly required - Takes 1-3 hours - Frame bolts together with expanding tube inserts, then clamp deck and use pilot holes in frame to drill and screw the top deck to frame.

Ramp deck - Two layers of 1/4" plywood (4x8 sheet cut in half) will work just fine, but it gets a little heavy for transporting. 1/8" or 3/16" Lexan (polycarbonate) will also work for a lighter setup, it needs to be ONE 4'x4' foot sheet. Do NOT get plexiglass (acrylic). Other plastics or metals will also work, but we haven't tested them. Because this requires a large deck it is best to find a local plastic supplier, that you won't need to pay shipping on.

- Specs -

- 55" long ramp when setup, folds to 48" for transport

- Folds down to 8" high or 6" if you remove legs.

- Weighs 30 lbs. with 1/8" lexan deck

- 1"x .125 wall 6061 aluminum (also made in USA) frame is easy to assemble with expanding tube inserts

1/27/26 - Product listed

Tube Holder - Flexible Tubing Clamp

$45.00

In Stock. FREE Shipping

Select Options

Push the Limits - T shirt - Gray

$20.00

In Stock. FREE Shipping

Select Options

Replacement parts - for Jack Extension

In Stock. FREE Shipping

Select Options

Off-road Jack Conversion - Pittsburgh - Combo Kit

$240.00

In Stock. FREE Shipping

(6)

Select Options

PT-60 Flat Cutting Tip Set - Plasma Torch Consumables

$50.00

In Stock. FREE Shipping

Select Options

20" x 32" Flat Ramp - 20°- 40° - Up to 1:8 Scale RC Jump

$70.00

In Stock. FREE Shipping

Select Options

1:5 Scale - 4'x4' - RC Car Ramp Jump - DIY Frame ONLY - 35-60°

Related Items